办公椅做测试需要哪些检测仪器？

答：东莞市海达仪器专业生产研发办公椅检测仪器，以下为您介绍办公椅检测项目以及相关仪器

测试项目：座面，靠背。                              
座椅座面的试验方法
Test Method for Seat Chair and seat surface:
1.座面的静载荷试验：通过加载块垂直向下施加一定力量于加载点上并保持至少10秒。并反复进行10次。
Seat Surface Static Load Test:
vertically down through the loading block to exert force on the load point and keep at least 10 seconds. And repeated 10 times
2.座面的疲劳试验：通过载入垫，将950N的力和规定的次数垂直向下重复施加在座面载入点上。加载速率为每分钟不超过40次。
Fatigue test of the seat: by loading pad, put 950N force and the specified times to repeat vertically down impose to the load point of the seat surface. Loading rate no more than 40 times per minute
3.座面的冲击试验：将一块泡沫塑料放在座面上，然后把座面冲击器置于规定的高度，使其自由跌落，冲击载入部位各10次。
Impact test of the seat: put a piece of foam on the seat surface, then place the impactor of the seat in a specified height and make it fall freely. impact loading site 10 times each.
办公桌椅综合测试仪，座椅靠背的试验方法：
Test methods for back of the chair
1.座背的静载荷试验：用挡块靠住椅和凳子的脚上。然后将规定的平衡载荷施加于座面载入点上。再将规定的力沿着与椅背垂直的方向通过载入垫施加于载入点上。每次至少保持10秒。并反复进行10次。
Static Load Test for back of the chair: put the baffle on the chair leg. Then impose the specified balance loading to the load point of the seat. And then provides the force perpendicular to the direction along the back pad by loading imposed on the load point. To keep at least 10 seconds each. And repeated 10 times.
2.座背的疲劳试验：用挡块靠住椅或者凳子的脚上，然后将950N的力垂直施加在座面载入点上，再通过椅背载入块，将330N的力按规定的次数施加在椅背的载入点上。加载速率为每份钟不超过40次。
Fatigue test of the seat back : use the block fixed the feet of the chair and then impose the 950N force vertically to the surface load point, through the back loading block. Impose 330 N force with specified times to the back loading site. Loading rate no more than 40 times per minute.

例：

办公椅旋转寿命试验机


办公椅脚轮耐磨试验机


办公椅扶手试验机


办公椅靠背反复试验机


办公椅冲击寿命试验机


海达仪器 所生产的办公椅检测仪器项目众多，受专利保护，在此不一一介绍，欢迎来电咨询：0769-89280808！